FLAT WALL INSTALLATIONS: 

    CORNER INSTALLATIONS: 

A: STOVE TO BACKWALL:
   SINGLE-WALL STOVEPIPE........ 9"
   DOUBLE-WALL STOVEPIPE........ 6"
   MANUFACTURED HOUSING*........ 7"
   ALCOVE INSTALLATION*......... 9" 

G: STOVE TO CORNER WALLS:
   SINGLE-WALL STOVEPIPE....... 4"
   DOUBLE-WALL STOVEPIPE....... 4"
   MANUFACTURED HOUSING*....... 5" 

B: STOVE TO SIDEWALL:
   SINGLE-WALL STOVEPIPE........ 12"
   DOUBLE-WALL STOVEPIPE........ 12"
   MANUFACTURED HOUSING*........ 14"
   ALCOVE INSTALLATION*......... 15" 

H: CENTERLINE PIPE TO CORNER WALLS:
   SINGLE-WALL STOVEPIPE.. 18-3/4"
   DOUBLE-WALL STOVEPIPE.. 18-3/4"
   MANUFACTURED HOUSING*.. 19-3/4" 

C: CENTERLINE PIPE TO BACKWALL:
   SINGLE-WALL STOVEPIPE.... 17-1/2"
   DOUBLE-WALL STOVEPIPE.... 14-1/2"
   MANUFACTURED HOUSING*.... 15-1/2"
   ALCOVE INSTALLATION*..... 17-1/2" 

I: DIAGONAL FROM CORNER TO FRONT OF HEARTH:
   SINGLE-WALL STOVEPIPE...... 59"
   DOUBLE-WALL STOVEPIPE...... 59"
   MANUFACTURED HOUSING*...... 61" 

D: CENTERLINE PIPE TO SIDEWALL:
   SINGLE-WALL STOVEPIPE... 24-3/4"
   DOUBLE-WALL STOVEPIPE... 24-3/4"
   MANUFACTURED HOUSING*... 26-3/4"
   ALCOVE INSTALLATION*.... 29-5/8" 

J: CORNER TO EDGE OF HEARTH:
   SINGLE-WALL STOVEPIPE...... 56"
   DOUBLE-WALL STOVEPIPE...... 56"
   MANUFACTURED HOUSING*...... 57" 

E: MINIMUM HEARTH WIDTH........ 38" 

L: MINIMUM WIDTH OF FRONT OF HEARTH... 37-1/2" 

F: BACKWALL TO FRONT OF HEARTH:
   SINGLE-WALL STOVEPIPE....... 52"
   DOUBLE-WALL STOVEPIPE....... 49"
   MANUFACTURED HOUSING*....... 50"
   ALCOVE INSTALLATION*........ 52" 

 * DOUBLE-WALL PIPE IS REQUIRED FOR ALCOVE
   AND MANUFACTURED HOUSING INSTALLATIONS 

COMBUSTIBLE ALCOVE DIMENSIONS:  
MINIMUM 59-1/4" Wide
MINIMUM 90" Tall
MAXIMUM 48" Deep 

OUTSIDE AIR SUPPLIED FROM VENTILATED CRAWLSPACE

Insert a length of 4" rigid or flexible aluminum intake pipe into the knockout hole in the bottom of the air plenum and extend it down through a 4-1/8" hole in the floor, terminating below the floor insulation. Caulk around the intake pipe and use silicone cement to glue a piece of 1/4" wire rodent mesh to the bottom.

OUTSIDE AIR SUPPLIED THROUGH BACKWALL

Insert a length of 4" rigid or flexible aluminum pipe into the knockout hole in the bottom of the air plenum and elbow back through a 4-1/8" hole in the outside wall behind the stove. Attach a 4" dryer vent termination on the outside of the wall, removing the flapper and substituting a piece of 1/4" rodent mesh cemented in place.